Skoda Octavia Workshop Manual page 45

OCTAVIA
Edition 04.03
S00.5127.54.20
Crank Assembly
Installing PTFE seal
Note:
The sealing lips of the seal must not be oiled or
greased.
- Use a clean cloth to remove oil residues on
the crankshaft journal.
K - Fit guide sleeve T10053/1 onto the crank-
shaft journal.
- Push seal over guide sleeve onto the crank-
shaft journal.
K - Use thrust sleeve T10053 to press in seal
as far as the stop.
Use old central bolt of crankshaft toothed belt
sprocket for this step.
Continued for both versions
K - Install crankshaft toothed belt sprocket and
lock with locking lever T30004 or counter-
holder MP 1-310.
Notes:
♦ When bolting on counterholder, place 2
washers between toothed belt sprocket and
counterholder.
♦ Replacing central bolt for crankshaft toothed
belt sprocket.
♦ When tightening the central bolt, the crank-
shaft must turn
- Tighten central bolt for crankshaft toothed
belt sprocket to
90 Nm + torque a further ¼ turn (90°).
- Installing toothed belt ⇒ page 13-5
13
------------ 13-17 -------------