Skoda Octavia Workshop Manual page 22

10
------------ 10-14 -------------
Removing and Installing Engine
Models with air conditioning
- Install the AC compressor.
⇒ Heating, Air Conditioning; Repair Group 87;
Servicing heating and air conditioning - en-
gine compartment
K - Knock back threaded bushes -B- for retain-
ing bolts -A- slightly in direction of arrow to
more easily fit on the AC compressor.
Continued for all models
- Install hydraulic pump for power steering.
⇒ Running Gear; Repair Group 48; Remov-
ing and installing hydraulic pump
- Install right drive shaft and bolt left drive shaft
onto gearbox.
⇒ Running Gear; Repair Group 40; Remov-
ing and installing drive shafts
- Install front exhaust pipe together with cata-
lytic converter ⇒ page 26-1, and align ex-
haust system free of stress ⇒ page 26-6.
Note:
Avoid excessively deflecting the decoupling el-
ement at the front exhaust pipe (max. 10°).
- Electrical connections and routing.
⇒ ”Current Flow Diagrams, Electrical Fault
Finding and Fitting Locations” binder
K - Install top part of intake manifold.
♦ Pay attention to installation position of
♦ Attachment of top part of intake manifold
- Adjust throttle cable ⇒ page 20-13
- Install ribbed V-belt ⇒ page 13-1.
- Attach coolant hoses ⇒ page 19-1.
Note:
Re-use drained coolant only if cylinder block,
cylinder head, radiator or heat exchanger have
not been replaced.
- Fill system with coolant ⇒ page 19-3.
gasket:
Component number -arrow- at top left (in
direction of arrow)
at front:
Insert rear bolts into top part of intake
manifold before installing.
OCTAVIA
Edition 08.99
S00.5127.50.20