Skoda Octavia Workshop Manual page 96

17
" # $ " %
------------ -------------
¢ £ ¤ ¥ ¥ ¦ ¡
¡ § ¤ ¡
¢   £ ¢ ¤ ¡ ¨
¤
! ¨ ¦ £ ¦ 
 ¡ ¡ ¢
Lubrication System
l Chain tensioner pretensioned
⇒ page 17-12.
K - Insert gearbox with balance shafts.
- Insert bolts working from the middle toward
the outside and tighten to 15 Nm and then
torque a further 90° (¼ turn).
Note:
Pay attention to arrangement of bolts on gear-
box with balance shafts ⇒ page 17-1.2.
K - Position crankshaft to top dead centre of
cylinder 1.
K - Align marking on balance shaft chain
sprocket -arrow- with adjusting hole and lock
with a pin T 10060.
- Fit chain onto the balance shaft chain
sprocket.
- Set milled side of oil pump shaft at right an-
gles to direction of travel.
- Install chain sprocket for oil pump and tighten
bolt by hand.
Note:
It is only possible to fit on chain sprocket for oil
pump in one position. When installing, rotate with
oil pump.
¨ ¢ © £ £ ¦ ¡   ¦ £ 
§ § © ¤   
¦ ¥ 
  
 ¤ ¥ ¤ ¡
 ©
OCTAVIA
Edition 01.02
S00.5127.53.20