Skoda Octavia Workshop Manual page 115

¡ ¢ £ ¤ ¥ ¦ § ¨ ¦ £
© §  ¥    ¤ ¤ £  ¥   ¤
¡
¡
¡ ¢
¡
 ¡  §   £ 
OCTAVIA
8
♦ Inspecting ⇒ Fig. 1
   £ ¨ 
¡
9
¡
10 10 Nm
¡
11 ent line
12 Fuel tank
  ¦ £  § ¤ £ ¨
¡
♦ Removing and installing
⇒ page 20-6
1 Clamping
¡
♦ Removing: turn to the left
♦ Installing: tighten to 2 Nm
¡
14 Heat
♦ For fuel tank
15 25 Nm
16 Clamping nut
¡
♦ Installing: tighten to 2 Nm
17
♦ For fuel tank
♦ Not fitted to all models
18 Tensioning strap
♦ Pay attention to different length
19 Feed line
♦ black
♦ To fuel rail
♦ For detaching, press in release but-
tons on connection piece
20 Fuel filter
♦ Installation position: arrow points in
direction of flow
Edition 08.99
S00.5127.50.20
¡
¡
 ¡ " # £ ¨  £ ¨  ¦ £  $ # ¤  ¥
Fuel Supply System
21 Retaining
♦ For fuel filter
22 Seal
¡
♦ Moisten with fuel for installing
♦ Replace if damaged
2
¡
♦ Removing and installing
⇒ page 20-5
♦ Testing fuel pump ⇒ page 20-9
♦ Removing and installing fuel gauge
sender ⇒ page 20-6
♦ Testing holding pressure:
⇒ 2.0-ltr./85 kW Engine, Motronic Fuel Injec-
tion and Ignition System; Repair Group 24;
% £ ¥ #  ¤ ¡ & ¨   ¨  ¤ £
¡
Testing fuel pressure regulator and holding
pressure
24 Union nut
♦ Use wrench MP 1-227 for removing
and installing
25 Feed line
♦ black
♦ To fuel filter
♦ Attached to connection marked with
„V“ at flange
♦ For detaching from flange, press in
release buttons on connection piece
26
¤  £  ¥  ¤
♦ blue
♦ From fuel rail
♦ Is attached to connection marked with
„R“ at flange
♦ For detaching from flange, press in
release buttons on connection piece
K Fig. 1 I
Lever in off position: closed
Lever pushed in direction of arrow: open
 ¨ §
!
¦ £ ¤ ¥ ¦ § ¨ ¦ £
'
------------ 20- -------------
20