Lubrication System Page; Removing And Installing Parts Of The Lubrication System - Skoda Octavia 1996 Service Manual

OCTAVIA

Removing and installing parts of the lubrication system

Notes:
♦ If considerable quantities of metal swarf or
abrasion are found in the engine oil when
carrying out engine repairs, it is then neces-
sary to carefully clean the oil galleries and,
in addition, to replace the oil cooler in order
to avoid consequential damage.
♦ The engine oil level must not extend beyond
the max. marking - risk of damage to cata-
lytic converter!
Inspecting engine oil level, quantity of oil and oil
specification:
⇒ Inspection and Maintenance
1 - Oil pump
♦ Duocentric pump with 1.2 MPa (bar)
pressure relief valve
♦ before installing, check whether the
two dowel sleeves for centering oil
pump/cylinder block are present
♦ if scores exist on running surfaces and
gears, replace
♦ torque of oil pump cover to oil pump
housing: 10 Nm
2 - Chain sprocket for oil pump
♦ pay attention to installation position
♦ can only be fitted onto the oil pump
shaft in one position
Edition 10.02
S00.5105.54.20
Lubrication System
3 - 20 Nm
4 - Chain for oil pump
5 - Sealing flange
♦ insert with silicone sealant D 176 404
A2 ⇒ page 13-17
♦ replacing crankshaft seal
⇒ page 13-14
6 - 15 Nm
7 - Collar bolt, 15 Nm
8 - Bush
9 - Chain tensioner
♦ in assembly with items 7, 8, 10 and
11
10 - Spring
11 - Washer
12 - Chain sprocket
13 - O-ring
♦ replace
14 - 15 Nm
15 - Suction line
♦ clean strainer if soiled
16 - Splash plate
17 - 15 Nm
18 - 15 Nm
♦ slacken and tighten with socket wrench
19 - Oil pan
♦ install with silicone sealant D 176 404
A2 ⇒ page 17-4
20 - Seal
♦ replace
21 - Oil drain plug, 30 Nm
17
------------ 17-1 ------------