Mix Bus Auto Punch; Join; Capture; Snap Mode - Euphonix System 5 Manual

System 5 Digital Audio Mixing System Operation Manual
Rehearse
Reh switches the Control Room monitor source from Mix Bus Outputs (playback) to
Mix Bus Returns (input), allowing you to listen to the recorder tracks (see page 216).
Reh works only on tracks you have record-enabled.
14.9.2

Mix Bus Auto Punch

With Mix Bus Auto Punch enabled, automation punches in on all mix sections when
any one of them is automated. This reduces the chances of double bussing a channel by
ensuring that the routing change is written across all the stems (see Figure 14-12).
14.9.3

Join

When the tape stops while recording automation, the pass ends and any parameters still
recording are automatically punched out. It is useful to remember which parameters
were punched in when the tape stopped so they can be punched back in automatically
during the next pass. Join and Auto Join offer different ways to accomplish this auto-
matic punch-in function.
Press the Join key during the pass in which you wish to remember the punched in pa-
rameters. After stopping the tape and resuming recording automation, press the Join
key again to punch in all parameters from the last pass.
Auto Join
Press the Auto Join key during the pass in which you wish to remember the punched
in parameters. After stopping the tape, rewinding, and resuming recording automation,
all parameters from the last pass are automatically punched in when the tape arrives at
the end of the last pass.
14.9.4

Capture

Press the Capture key to take a snapshot of all objects currently in record or preview
and stores their values in the a Capture Buffer. If no objects are in record or preview,
no action is taken and the current Capture Buffer is maintained.
Punch Capture
Press the Punch Capture key to drop all objects in the Capture Buffer into record at
their captured values.
14.9.5

Snap Mode

Snap Mode overrides the A/Glide or M/Glide times for knobs and faders set to Auto or
Manual Glide by causing the knob or fader to abruptly shift from the level at the
punch-out point to the underlying automation level. Snap Mode is activated in the Au-
tomation Panel Page 1.
204
Dynamic Automation