Setting Auto And Manual Glide Times - Euphonix System 5 Manual

System 5 Digital Audio Mixing System Operation Manual
The Glide key in the center section Automation Panel can also be used to toggle the
fader's status:
1. Activate Knob Touch Enabled (see page 106).
2. Press the Glide key so it illuminates.
3. Press the knob.
Toggling the Glide settings is closely related to setting the automation mode.
Continuing to hold down the Wave key and repeatedly pressing the Function
Select key cycles through the automation modes. To toggle the Glide setting,
be sure to press the Function Select key once and then release both keys.
If Auto Glide is not selected, then the fader or knob is in Manual Glide mode.
Toggling ATO and Manual Glide
To toggle the knob's ATO/Manual Glide status:
1. Turn Knob Touch Enabled off (see page 106).
2. Press and hold down the Wave key.
3. Press the knob once.
4. Release both keys.
The screen above the Strip indicates either ATO or Manual Glide status for the knobs
only, not the fader.
14.7.3

Setting Auto and Manual Glide Times

To set the Auto Glide time in the Automation Panel:
1. From the Main Panel, press the Automation button to display Automation
Panel Page 1.
2. Enter a timecode into the locate time display using the numeric keypad on the
center section (Figure 14-13).
The entire time must be entered, beginning with frames. When the first numeric
key is pressed, the display clears to enter the new value.
3. Press Store Locate and then the A/Glide key in Automation Panel Page 1 to
transfer the locate time to the A/Glide field.
Perform the same steps to set the M/Glide time but press the M/Glide key instead of
the A/Glide key in step 3.
193
Dynamic Automation