Store Locate Value To A Register; Store Current Value To A Register - Euphonix System 5 Manual

System 5 Digital Audio Mixing System Operation Manual
Film Type
The Feet+Frames display can be set to 35 mm, 35 mm 25 Fr, 16 mm, or 16 mm Key
(half-feet).
Entering and Modifying Time Displays
There are three ways to enter a time into the Locate Time Display:
•
Numeric Keypad: Use the numbers along the left of the Machine Control Panel
to enter a time. To enter 5 seconds, press 5, 0, 0, Enter. It is not necessary to
enter leading zeros.
•
Transfer Current Time to Locate Time: Press the downward arrow to the
right of the Current Time Display to transfer it to the Locate Time Display.
•
Recall Key: Press the Recall key (it flashes), then press Pre-Roll, Post-Roll,
Rollback, T/Start, T/End, R/Start or R/End in the Locate Registers Panel
to transfer its value to the Locate Time Display.
There are two ways to modify the Locate Time:
•
Use the Trim + and Trim - keys to add or subtract one frame to or from the
Locate Time.
•
Press the Trim key (it flashes) below the Enter key to use the SpinKnob to mod-
ify the Locate Time. Press the Trim key again (to stop flashing) when finished.
12.2.2

Store Locate Value to a Register

Press the Store Locate key (it flashes until destination key pressed) followed by the
Pre-Roll, Post-Roll, Rollback, T/Start, T/End, R/Start or R/End keys to store the
Locate Time to that register. See page 156 to see how to store to the FF o-set key.
12.2.3

Store Current Value to a Register

Press the Store Current key (it flashes until destination key pressed) followed by the
Pre-Roll, Post-Roll, Rollback, T/Start, T/End, R/Start or R/End keys to store the
Current Time to that register. See page 156 to see how to store to the FF o-set key.
Mark In/Mark Out
Press Mark In or Mark Out to capture the Current Time into the R/Start or R/End
parameters, respectively. Press the Store Locate key before pressing Mark In or Mark
Out, to capture the Locate Time instead of the Current Time. Press the Recall key and
then Mark In or Mark Out to recall the stored R/Start or R/End time to the Locate
Time display.
157
Machine Control