Knob Glide Modes - Euphonix System 5 Manual

System 5 Digital Audio Mixing System Operation Manual
The Glide key in the center section Automation Panel can also be used to toggle the
fader's status:
1. Press the Glide key so it illuminates.
2. Press the Chan Select key.
ATO
ATO is independent of the fader's Auto/Manual Glide status. ATO can be set "on the
fly" to override either Auto or Manual Glide:
1. While holding the fader, press its Select/Punch key.
The red automation LED blinks rapidly.
2. Move the fader until its level intersects with that of the underlying automation.
The fader automatically punches out.
The ATO status is not sticky: the current Auto/Manual Glide setting resumes control
during the next automation record session.
14.7.2

Knob Glide Modes

If Knob Touch Enabled is activated (see page 106), Auto and Manual Glide inter-
cancel. Knobs will always be set to Auto or Manual Glide and they toggle between
values.
Manual Glide functions the same way for knobs as faders: after manually punching out
with the knob's Select/Punch or All Match key, the control uses the time set in the
M/Glide field in the Automation Panel Page 1 to glide from the setting at the punch-out
point to the underlying automation.
Toggling Auto and Manual Glide
To toggle the knob's Auto/Manual Glide status:
1. Activate Knob Touch Enabled (see page 106).
2. Press and hold down the Wave key.
3. Press the strip's Func Select key once.
4. Release both keys.
The screen above the Strip indicates either Auto or Manual Glide status for the knobs
only, not the fader.
Alternately, press the Glide key in the Automation Panel and then the Knobs key in
the All Panel to toggle between Auto (Glide key lit) and Manual Glide.
192
Dynamic Automation