Fill Region + Fill Start + Fill End; Fill Region + Fill End - Euphonix System 5 Manual

System 5 Digital Audio Mixing System Operation Manual
To adjust the AR/Start time by a few frames:
1. On the center section, press Recall then AR/Start to transfer the AR/Start
time to the locate time display.
2. Press the Trim +/- keys to alter the value in one frame increments.
3. Press Store Locate and then AR/Start to transfer the new value to the AR/Start
field.
To modify the AR/End time, perform the same steps but substitute the AR/End for
the AR/Start key.
NOTE: To set AR/Start and AR/End times, the center section Fill Start and Fill End
keys can be used interchangeably with the AR/Start and AR/End keys.
1 4 8 . 6 . F l l i R e g o i
Fill Region is used in combination with Fill Start and Fill End to set a value for a defined
region rather than throughout the mix. The punch-out point must be within the defined
region for the fill to apply.
1. Record a fader level from 00:01:00:00 to 00:02:00:00 so you can see how the
new level will override an existing one.
2. Enter 00:01:00:00 into the AR/Start field and 00:02:00:00 into the AR/End
field.
See Section 14.8.5 - Setting Fill Start and End Times to see how to set the
times.
3. Now activate Fill Start, Fill End and Fill Region.
4. Record the new fader level in this section and punch out at the desired level.
The new level will be written from 1 to 2 minutes.
14.8.7

Fill Region + Fill End

1. Set the AR/End time.
See Section 14.8.5 - Setting Fill Start and End Times to see how to set the
times.
2. Activate Fill End and Fill Region. Do not activate Fill Start.
n + F l l i S a t t r + F l l i
Fill
Region
Fill
E n d
Region
Fill
201
Dynamic Automation
Fill Fill