Recording Automation; Knobs And Faders; Knob (Left) And Fader (Right) Punch Record Methods - Euphonix System 5 Manual

System 5 Digital Audio Mixing System Operation Manual
14.5

Recording Automation

Since Isolate is the default mode for all parameters, the read and write LEDs are off
at the beginning of a new mixing session. Automation cannot be recorded or played
back unless the Mix On key is lit at the top-left of the center section Automation
Panel in Figure 14-1.
14.5.1

Knobs and Faders

To record basic fader and knob automation:
1. Press the Mix On button so it is illuminated.
2. Set any parameters that will record automation to Write Absolute or Write Trim.
3. Play an audio source that sends timecode into the console.
4. Press the parameter's Select/Punch key or touch the fader to punch in.
The parameter's automation LED flashes red. The Chan Select key cannot be
used to punch in an entire channel.
5. Adjust the parameter.
6. Press the Select/Punch key or release the fader to punch out.
Press the All Funcs key to punch out all knobset parameters.
Punch
Write Record
Ready
Can be manually Moves will be
operated recorded
Figure 14-5 Knob (left) and fader (right) punch record methods
Punch
Write
Ready
Can be manually
operated
Time
186
Dynamic Automation
Touch
Release
Write Record
Ready
Write
Ready
Time