Euphonix System 5 Manual page 106

System 5 Digital Audio Mixing System Operation Manual
Direct Assign: Allows assigning a channel to a joystick via the Channel Assign
Panel (see page 98). Allows assigning a Control Group or Bus to a joystick via
the Busses Assign Panel (see page 99). Direct Assign is always active even if
its key is not selected.
402 Cycle: Allows assigning a joystick to a channel from the CM402T Channel
Select keys (see page 83). Left/right joystick assignments alternate with each
Channel Select key press.
Delay Display Modes
In the Strips Config Panel (page 3), there are three delay display modes available
to view and access for adjusting on the channel strip when the Dly parameter is
selected (see page 115):
Mode
Samples
Seconds/Frames
Seconds/Millisec(ond)s
Aux View Enabled
The Aux View Enable function in the Strips Config Panel (page 4) is not
currently implemented.
Knob Touch Enabled
If Knob Text is set to Momentary Values (see page 104), selecting Knob
Touch Enabled in the Strips Config Panel (page 4) will cause the knob
displays to show their values when the knob is touched. If Knob Touch
Punch is enabled (see page 186), selecting Knob Touch Enabled will allow
the knobs to punch in when touched and automation is running.
Input Delay Units
kS (kilo-samples), S (samples)
Sec (seconds), Fr (frames), sFr (sub-frames),
S (samples)
Sec (seconds), mSec (milliseconds), S (samples)
106
Channels and Strips