Installing Hardware Options; Opening The Front Bezel And Removing The Side Access Panel - Compaq ProLiant 5000 Reference Manual

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Installing Hardware Options

WARNING:
equipment when installing options, make sure that the power to the server
is off and disconnect the AC power cord.
CAUTION:
Be sure you are properly grounded before beginning any installation
procedure. Refer to Appendix C, "Electrostatic Discharge," for more
information
Opening the Front Bezel
and Removing
the Side Access Panel
1. Open the front bezel (door) by turning the keylock and swinging the
bezel to the right.
Figure 2-3.
Writer: Compaq Project: Installing the Compaq ProLiant 5000 Server Comments:
To avoid the risk of personal injury or damage to the
Electrostatic discharge can damage electronic components.
Unlocking the front bezel
File Name: F-ch2.doc Last Saved On: 4/18/97 5:09 PM
Compaq ProLiant 5000 Servers Reference Guide
2-5