Jigs And Tools; Required Tools - MUTOH ValueJet 1304 Service Manual

10 Appendix

10.4 Jigs and Tools

This section provides lists of jigs and tools required for service operations.

10.4.1 Required Tools

(1) Tools for Part Replacement
No. Name
1 Phillips driver No.2
2 Phillips driver No.2
3 Phillips driver No.1
4 Flat-head driver
5 Longnose plier
6 Tweezers
7 Hex wrench (opposite side:
6mm)
8 Tube cutter
(2) Tools for Adjustment
No. Name
1 Personal computer
2 Tension gauge
3 Tension gauge
4 MF-3G
5 Straight scale (1000mm)
6 Jig cutter holder (VJ)
7 PG height check tool (VJ13)
Rev.-01
CS9050, CS9150
Table 10-2 Tools for Part Replacement
Part number
Generic product
Generic product
Generic product
Generic product
Generic product
Generic product
Optional stand
accessory (Generic
product)
Generic product
Table 10-3 Tools for Adjustment
Part number
Generic product
Generic product
Generic product
Exclusive use media Used for media sensor adjustment
Generic product
JD-42804
JD-42806
10-8
VJ-1304 Maintenance Manual
Remarks
More than 250mm shaft length is
recommended
Less than 50mm shaft length is
recommended
Required only when disassembling legs
Required when cutting the tube
Remarks
Max. 10,000gf (100N) for measurement
Max. 5,000gf (50N) for measurement
(P_REAR sensor and P_EDGE sensor) and
for print accuracy adjustment