MUTOH ValueJet 1304 Service Manual page 366

9 Troubleshooting
Table 9-6 Error Messages During File Transmission (Continued)
No. Message
17 Boot Transfer AA did not
failed replied to Step
55-AA 55 of boot code
Timeout transfer.
18 Boot Transfer xx replied to
failed Step 55 of boot
55-AA reply code transfer.
error xx
19 Boot Transfer An error (xx)
failed replied to
End code xx transfer end of
boot code.
20 Boot Transfer Transfer
failed sequence echo
Echo timeout of boot code
did not reply.
21 Boot Transfer Invalid transfer
failed sequence echo
Echo error xx of boot code
did not reply.
22 Internal error Failed in
Parameter save writing
error parameter.
23 Transfer failed Invalid year
Wrong year data (xxxx)
xxxx received.
24 Transfer failed Invalid month
Wrong month data (xx)
xx received.
25 Transfer failed Invalid day
Wrong date data (xx)
xx received.
26 Transfer failed Invalid hour
Wrong hour data (xx)
xx received.
27 Transfer failed Invalid minute
Wrong min
data (xx)
xx received.
Rev.-01
CS9050, CS9150
Event/ Check item
symptom
Check connection
between control board
and main board.
Normally not occurred.
FROM may be
defective.
SODIMM or main
board may be defective.
9-28
VJ-1304 Maintenance Manual
Action
• Reconnect control
board and main
board.
• Replace the cable
connecting control
board and main
board.
• Replace control
board.
• Replace main
board.
Replace main board.
• Replace SODIMM.
• Replace main
board.
Reference
"4.3.4
Replacing
HEATER
CONT board
assembly"
p.4-27
"4.3.3
Replacing
Main Board
Assembly"
p.4-26
"4.3.3
Replacing
Main Board
Assembly"
p.4-26