Operation Status - MUTOH ValueJet 1304 Service Manual

VJ-1304 Maintenance Manual
9.2.1

Operation Status

This section describes the message contents, check items, and recovery actions for normal operation.
These messages appear on LCD, and the machine stops its operation at the same time.
Table 9-2 Events and Check Items for Operation Status Messages
No. Message
1 Cover Open Front cover is
open.
2 Lever Up Media holding
lever is turned
backward.
CS9050, CS9150
Event/ Check item
symptom
Is cover sensor
assembly loose?
1. Is cover sensor
assembly cable
connected securely?
2. Does pressure lever
move smoothly?
3. Is lever sensor
assembly fitted
correctly?
4. Is sensor of lever
sensor assembly
contaminated?
5. Is lever sensor
cable connected
securely?
6. Check the cover
sensor from "Sen
4:Cover" of self-
diagnosis function.
7. Check the lever
sensor from "Sen
5:Lever" of self-
diagnosis function.
9-3
9 Troubleshooting
Action
Tighten cover sensor
assembly screws. Replacing
Cover Sensor
Assembly"
p.4-78
Correctly connect cover
sensor assembly cables Replacing
to main board assembly Main Board
connector J117. Assembly"
p.4-26
Lubricate pressure cam.
Lubrication/
Bonding"
p.8-7
Adjust lever sensor
assembly position. Replacing
Lever
Sensor" p.4-
49
Clean sensor face using
a swab. Replacing
Lever
Sensor" p.4-
49
Correctly connect lever
sensor assembly cables Replacing
to main board assembly Lever
connector J132. Sensor" p.4-
49
Replace cover sensor
assembly. Replacing
Cover Sensor
Assembly"
p.4-78
Replace lever sensor
assembly. Replacing T
Fence" p.4-50
Reference
"4.8.3
"4.3.3
"8.4
"4.5.3
"4.5.3
"4.5.3
"4.8.3
"4.5.4
Rev.-01