Cutter Holder Height Adjustment; Jigs And Tools; Adjustment Procedure - MUTOH ValueJet 1304 Service Manual

VJ-1304 Maintenance Manual
3. Loosen the vertical-slant adjusting tab screw and move the tab left and right to adjust the head vertical
angle.

7.10 Cutter Holder Height Adjustment

This section describes the procedure to adjust the cutter holder height.

7.10.1 Jigs and Tools

The following jigs and tools are required for cutter holder height adjustment.
• Cutter holder jig (VJ): JD-42804
TIP
"10.4 Jigs and Tools" p.10-8

7.10.2 Adjustment Procedure

NOTE
Before starting adjustment, remove the following parts.
• Cable cover L
To make adjustment, follow the steps below.
CS9050, CS9150
"4.6.1 Replacing Print Head" p.4-56
7-75
No. Part name
1
Vertical-slant adjusting tab
2
Vertical-slant adjusting tab
screw
7 Adjustment
Rev.-01