MUTOH ValueJet 1304 Service Manual page 18

1 Safety Instructions
Do not insert or drop metal or flammable objects into the printer through openings
such as a fresh air inlet. It could lead to an electric shock and fire.
When foreign substances or liquids such as water entered the printer, do not use
the printer as it is. It could lead to an electric shock and fire. Immediately turn OFF
the power switch, disconnect the power plug from the electric socket.
Be sure to use the power cable supplied with the printer. If other power cables are
used, it would cause an electric shock or fire.
Make sure to use only the specified power supply (AC 100 V - 120 V or AC 220 V -
240 V). If the power supply other than the specified voltage is used, it could cause
an electric shock and fire.
Take power for the printer directly from the power socket (AC 100 V - 120 V or AC
220 V - 240 V). Do not use complex multiple plugs on the same socket. This could
generate heat and might cause fire.
Be sure to use a dedicated power socket with earth wire for the power supply, and
connect it to the earth wire. If the earth wire is not connected, an electric shock or
fire may occur.
The waste fluid from the printer is a waste oil (waste ink) of industrial waste. Proper
waste fluid disposal according to industrial waste disposal laws and ordinances of
your local governments are required. Consign disposal of waste fluids to specialized
processor.
Rev.-01
CS9050, CS9150
1-4
VJ-1304 Maintenance Manual