4 Parts Replacement
4.12.7 Replacing Peripheral Devices of VJ Take Up Unit Motor Assembly
(1) Replacing Drive Roller
1. Remove the flat head screws (set screw (top cup point) M4
the drive axis C.
1
2. Remove the drive roller.
3. To reassemble the unit, reverse the removal procedure.
(2) Replacing VJ Take Up Unit Motor Assembly
CAUTION
Do not touch the motor right after starting-up the plotter. Otherwise, you may be burned.
NOTE
Remove the following parts before replacing the VJ take up unit motor assembly.
• Take Up Unit cover:
• Screw for the board chassis:
Rev.-01
CS9050, CS9150
2
3
"4.12.3 Removing Take Up Unit Cover" p.4-96
"(1) Removing Board Chassis" p.4-99
4-110
VJ-1304 Maintenance Manual
×
6: 2 pieces) that retain the drive roller on
No.
Part name
1
Drive roller
2
Screws that retain the drive
roller (set screw (top cup point)
×
M4
6)
3
Drive axis C