MUTOH ValueJet 1304 Service Manual page 125

VJ-1304 Maintenance Manual
6. Replace the ink cable assembly.
7. To reassemble the unit, reverse the removal procedure.
NOTE
When reassembling the unit, note the following sensor fastening torque.
• Ink NOT sensor: Slight overtorque may damage the parts. Gradually torque the sensor to avoid
tightening it too much.
• Confirm that the switch is not stuck when it is pressed.
• Ink END sensor: Tighten the sensor to avoid rattling.
CS9050, CS9150
4-77
4 Parts Replacement
Rev.-01