MUTOH ValueJet 1304 Service Manual page 252

7 Adjustment
Part replaced or Adjustment
adjusted
T fence
CR driven pulley
Cutter holder
assembly
Carriage assembly
Rev.-01
CS9050, CS9150
Table 7-1 Adjustment Item List (Continued)
Adjustment item
order
1 CR encoder inspection
2 Uni-D / Bi-D Low Adjustment
Uni-D / Bi-D High Adjustment
3 Side margin adjustment
4 Test printing
1 CR belt tension adjustment
1 Cutter holder assembly mounting
position adjustment
2 P_EDGE sensor adjustment
3 Print margin adjustment
1 CR belt tension adjustment
2 CR encoder inspection
3 Cutter holder assembly mounting
position adjustment
4 P_EDGE sensor adjustment
5 Sequential printing endurance operation
check
7-6
VJ-1304 Maintenance Manual
Reference
"5.5.5 Encoder
Menu" p.5-17
"5.7.6 Uni-D / Bi-D
Low and High
Adjustment" p.5-36
"5.7.7 Side Margin
Adjustment Menu"
p.5-42
"5.7.8 Test
Printing Menu" p.5-43
"7.7 CR Belt
Tension Adjustment"
p.7-70
"7.10 Cutter
Holder Height
Adjustment" p.7-75
"7.12.1 P_EDGE
Sensor Sensitivity
Adjustment" p.7-80
"5.7.7 Side Margin
Adjustment Menu"
p.5-42
"7.7 CR Belt
Tension Adjustment"
p.7-70
"5.5.5 Encoder
Menu" p.5-17
"7.10 Cutter
Holder Height
Adjustment" p.7-75
"7.12.1 P_EDGE
Sensor Sensitivity
Adjustment" p.7-80
"5.13.4 Print Head
Endurance (Nozzle
Print) Menu" p.5-71