MUTOH ValueJet 1304 Service Manual page 361

VJ-1304 Maintenance Manual
Table 9-5 Symptoms and Check Items for Mechanical Serious Errors (Continued)
No. Message
16 E 081 error CR_HP
CR origin detection is not
possible.
17 E 082 error Abnormal
wiper sensor condition in
wiper sensor.
18 E084Err Head Installed head
Dist. is incorrect.
19 E 085 error Abnormal
head overheat condition in
head driver.
20 E 086 error Abnormal
head OVP condition in
head driver.
CS9050, CS9150
Event/ Check item
symptom
1. Check CR_HP
sensor from "Sen1:
CR Origin" of self-
diagnosis function.
2. CR_HP sensor may
be damaged.
3. Main board
assembly may be
damaged.
• Wiper sensor
assembly may be
faulty.
• Maintenance
assembly may be
damaged.
• Main board
assembly may be
faulty.
Installed head is not
manufactured by other
vendor.
Main board assembly
may be damaged.
Head or head cable may
be damaged.
9-23
9 Troubleshooting
Action
• Check connection
of CR_HP sensor Sensor
cable assembly Menu" p.5-15
connector.
• Replace CR_HP
sensor. Replacing CR
Origin Point
Sensor" p.4-
47
• Replace main board
assembly. Replacing
Main Board
Assembly"
p.4-26
1. Check connection
of wiper sensor Replacing
connector. Cleaner Head
(Cleaning
2. Replace wiper
Wiper)" p.4-
sensor.
71
3. Replace wiper
Replacement
origin cable
of Board Base
assembly.
Section
4. Replace pump cap
Components
assembly.
" p.4-21
5. Replace main board
assembly.
Replace head.
Replacing
Print Head"
p.4-56
Replace main board
assembly. Replacement
of Board Base
Section
Components
" p.4-21
1. Check connection
of head cable. Replacement
of Head
2. Replace head.
Section
Components
" p.4-56
Reference
"5.5.4
"4.5.2
"4.3.3
"4.7.3
"4.3
"4.6.1
"4.3
"4.6
Rev.-01