MUTOH ValueJet 1304 Service Manual page 149

VJ-1304 Maintenance Manual
(2) Replacing VJ Take Up Unit CNT Board Assembly
NOTE
Remove the screw that retains the board chassis.
"(1) Removing Board Chassis" p.4-99
1. Remove the cable of the DC cable assembly and the VJ take up unit SW board assembly from the
connector to the VJ take up unit CNT board assembly.
1
2. Remove the screws (round head spring screw finishing M3
CNT board assembly on the board chassis.
1
3
3. Remove the VJ take up unit CNT board assembly.
4. To reassemble the unit, reverse the removal procedure.
(3) Replacing Power Board Assembly (of take up unit section for foreign use)
NOTE
Remove the screws that retains the board chassis before replacing the power board assembly.
"(1) Removing Board Chassis" p.4-99
CS9050, CS9150
2
3
2
2
4-101
4 Parts Replacement
No. Part name
1 VJ take up unit CNT board
assembly
2 DC cable assembly
3 VJ take up unit SW board
assembly
×
6: 4 pieces) that retain the VJ take up unit
No. Part name
1 VJ take up unit CNT board
assembly
2 Screws that retain the VJ take up
unit CNT board assembly
(round head spring screw
×
finishing M3 6)
3 Board chassis
Rev.-01