MUTOH ValueJet 1304 Service Manual page 282

7 Adjustment
(8) Starting the Printer
You have to start the printer in a mode (described later) depending on the function you will use. The function
and the corresponding start mode is listed below.
NOTE
If the start mode is not appropriate, an error message will be displayed. In that case, select an
appropriate mode and restart the printer.
Table 7-2 MSA functions and start mode of the printer
MSA functions
"7.4.4 Date & Time Setting" p.7-40
"7.4.5 Editing Media Type" p.7-41
"7.4.6 Downloading and Saving Error
Log" p.7-43
"7.4.7 Updating Main Firmware" p.7-
47
"7.4.8 Updating the Firmware of
Heater Controller" p.7-48
"7.4.9 Receiving Parameters" p.7-49
"7.4.10 Sending Parameters" p.7-51
"7.4.11 Using Diagnostic Mode" p.7-54
"7.4.12 Downloading Individual Code"
p.7-58
"7.4.13 Uploading Authorization
Code" p.7-59
"7.4.14 Referring Setup List
Information" p.7-61
"7.4.15 Referring Adjust Parameters"
p.7-63
(8-a)Printer mode
Starts the printer with Printer mode.
Printer mode indicates the status that the printer is powered on normally by pressing the [Power] key on the
operation panel.
Rev.-01
CS9050, CS9150
Printer start mode
Start the printer with Board Manager mode.
Start the printer with Printer mode.
Start the printer with any mode
Start the printer with Board Manager mode.
Start the printer with Board Manager mode.
Start the printer with any mode
Start the printer with Board Manager mode.
Start the printer with Printer mode.
Start the printer with Board Manager mode.
Start the printer with Board Manager mode.
Start the printer with Printer mode.
Start the printer with Printer mode.
7-36
VJ-1304 Maintenance Manual