Heater; History - MUTOH ValueJet 1304 Service Manual

5 Self-Diagnosis Mode

5.15.3 Heater

In this menu, you can check whether pre-heater, platen heater, and after-heater works properly or not. The
printer sets the temperature at 50
operation.
If the temperature reaches to the set value, the printer keeps the temperature control.

5.15.4 History

You can check the maintenance history of the controller board control device. The history is displayed in H
(hour) / M (min.) / S (sec.).
Total operating time of each heater shows the period from when the printer is used in self-diagnosis mode.
Daily operating time is not counted.
[>] key
[>] key
[>] key
Rev.-01
CS9050, CS9150
°
C and controls the selected heater process. Press [Cancel] key to stop the
[>] key
[>] key
[>] key
[Enter] key When selecting Pre
[<] key
[<] key
[<] key
5-76
VJ-1304 Maintenance Manual
[<] key
[<] key
[<] key
Time of using Pre-heater
Time of using Platen Heater
Time of using After Dryer Heater