Head Alignment (Horizontal Height) - MUTOH ValueJet 1304 Service Manual

VJ-1304 Maintenance Manual
CAUTION
To align the graduation alignment pointer with the center line of driven pulley base, align the
left side (viewed from the front of the printer) of the pointer with the center line as shown
below.

7.8 Head Alignment (Horizontal Height)

This section describes the procedure to adjust the head slant in horizontal direction.
When you have removed and installed the head assembly, such as for head assembly replacement, always
adjust the head slant and depth following the steps below.
NOTE
Before starting adjustment, remove the following parts.
• CR board cover:
• Cable cover R:
Adjust the horizontal height of the head alignment before adjusting the vertical alignment slant of
head alignment.
In this procedure, align the print head in the direction shown below.
CS9050, CS9150
L side
Align them like this.
"4.6.1 Replacing Print Head" p.4-56
"4.6.1 Replacing Print Head" p.4-56
Alignment pointer
R side
Alignment pointer
Print head
7-71
7 Adjustment
Rev.-01