MUTOH ValueJet 1304 Service Manual page 139

VJ-1304 Maintenance Manual
6. Remove the following parts from the I/H backing plate.
• Tube guide film
• Steel bearer assembly
• CR cable (3 cables)
1
2
3
7. Replace the CR cable.
8. To reassemble the unit, reverse the removal procedure.
NOTE
When connecting the CR cable, note the following.
• The CR cable has three layers. Make sure to match the corresponding connector numbers.
• Remove or insert the CR cable terminal perpendicularly to the CR board connector. Pulling or
pushing the wire slantwise may damage/short/break the terminals in the connectors.
• Replace and use new terminal if it is damaged.
CS9050, CS9150
No.
1
2
3
4-91
4 Parts Replacement
Part name
Tube guide film
Steel bearer
CR cable
Rev.-01