Parameter Backup; Jigs And Tools - MUTOH ValueJet 1304 Service Manual

7 Adjustment
Workflow for Firmware installation (Version-up Procedure)
Confirm IP Adress of Printer
Set IP Address of PC
Execute Board Manager mode
Install Firmware
Confirm Firmware installation
7.3.1

Parameter Backup

The NVRAM (Flash-Rom) installed on the main board assembly stores various parameters for the system
operation.
The available backup parameters are as follows.
. Panel setting parameters
. Mechanism adjustment parameters
. Main board-unique adjustment parameters
TIP
The main board-unique adjustment parameters cannot be erased or modified.
If the main board assembly is found to need replacement during maintenance operations, make sure to back
up the parameters. The backup data can be used to restore the original system status, omitting some
adjustment steps.
7.3.2

Jigs and Tools

The following jigs and tools are required for MUTOH Maintenance Engineer Assistant operation.
• Windows PC:
• CPU: Pentium 400MHz or higher, Installed memory: 128MB or more
• With one of the following installed: Windows98/Windows98SE/WindowsMe/Windows2000/
WindowsXP
Rev.-01
CS9050, CS9150
End
7-10
VJ-1304 Maintenance Manual
Operation using MUTOH Maintenance
Engineer Assistant
Operation using operation panel