Pump Endurance Menu - MUTOH ValueJet 1304 Service Manual

5 Self-Diagnosis Mode

5.13.3 Pump Endurance Menu

This menu performs endurance running for the pump motor assembly.
You can drive the pump motor assembly according to your desired settings. The available settings are shown
below.
Table 5-21 Set Items in Pump Motor Assembly Endurance Menu
Set item
Running speed
Number of endurance
running cycles
TIP
• If the number of endurance running cycles is set to -1, the carriage continuously repeats endurance
running until cancel input is given from the operation panel.
• The maximum counter value for endurance running cycles is 99999999 (up to 8-digit number). If
the number of cycles exceeds the maximum value, the counter is reset to 0.
Rev.-01
CS9050, CS9150
Contents
Set the running speed of
pump motor assembly.
Set the number of endurance
running cycles
[>] key
[>] key
[>] key
[>] key
Endurance Count
Performing Endurance
5-70
VJ-1304 Maintenance Manual
Set value
Super High / High /
Normal
-1 to 10000
[<] key
[Enter]
[<] key
key
[Enter]
[<] key
key
[Enter]
[<] key
key
[Enter]
key
[Enter] key
[Enter] or [Cancel ] key
Remark