MUTOH ValueJet 1304 Service Manual page 19

CS9050, CS9150
VJ-1304 Maintenance Manual
1 Safety Instructions
CAUTION
Assembling and disassembling of the printer are possible only for the parts that
disassembling procedures are shown in this manual. Do not disassemble any frame
parts or parts that disassembling procedures are not shown in this manual.
Doing so may cause trouble that cannot be restored, as the printer is originally
assembled in the factory with a high accuracy of 1/100 mm.
Do not touch the elements on the circuit board with bare hands.
Doing so may cause static electricity and break the elements.
Do not press the transparent film on the damper assembly with your hands. Doing
so may discharge the ink filled inside the damper assembly.
Be careful not to damage the transparent film on the damper assembly.
Do not touch the nozzles of the print head. Make sure that the nozzles do not get
any dust.
There are some remaining ink in the tubes. Be careful that the ink is not spilled from
the tube outlet onto the printer or items close to the printer.
If you need to operate the printer with the cover removed for maintenance, be
careful not to get hurt by the driving parts.
Never lube the printer mechanism with lube other than that designated by MUTOH.
Doing so may damage the parts or shorten the lifetime.
If the power board assembly needs to be removed, remove the power cable and
wait for 5 minutes or more before taking it out; this will discharge the residual
electrical charge of the electrolytic capacitor.
Touching the board before the capacitor discharges may cause electric shock.
When connecting or removing an FFC type cable on a main board assembly
connector, make sure to connect or remove the cable perpendicular to the
connector.
Connecting or removing at a slant angle may damage, break or shortcircuit the inner
terminal of the connector. That may damage the elements on the board.
When connecting or removing an FFC type cable on the CR board assembly
connector, make sure to connect or remove the cable perpendicular to the
connector.
Connecting or removing at a slant angle may damage, break or shortcircuit the inner
terminal of the connector. That may damage the elements on the board.
Make sure there is sufficient space around the printer when performing
maintenance work.
Maintenance must be done by more than two persons for the following work.
• When disassembling or reassembling the product and the optional stand
• When packing the printer for transportation
1-5 Rev.-01