MUTOH ValueJet 1304 Service Manual page 198

5 Self-Diagnosis Mode
C: Executed adjustment item is printed like this.
Bi-D 240: Bi- Lo/Hi 240 CPS
Bi-D 320: Bi- Lo/Hi 320 CPS
Bi-D 240B: Bi- Lo/Hi 240 CPS Banner
Bi-D 320B: Bi- Lo/Hi 320 CPS Banner
* Either "Lo" or "Hi" is displayed at where explained as "Lo/Hi" above.
• The following shows a case for Bi-D Low 240B Print2
Prints the pattern by using 2A nozzle.
* Both Uni-D / Bi-D High should be adjusted in the same procedure.
- +
4B 4A 3B 3A 2B
A: Media feed direction
B: Adjust the setting value so that these point matches.
C: Executed adjustment item is printed like this.
Bi-D 240: Bi- Lo/Hi 240 CPS
Bi-D 320: Bi- Lo/Hi 320 CPS
Bi-D 240B: Bi- Lo/Hi 240 CPS Banner
Bi-D 320B: Bi- Lo/Hi 320 CPS Banner
* Either "Lo" or "Hi" is displayed at where explained as "Lo/Hi" above.
Rev.-01
CS9050, CS9150
- + - + - + - + - +
2A 1B
B
5-38
VJ-1304 Maintenance Manual
Bi-Lo
240CPS
- + - +
1A
C
A