Sensor (Finisher Media Entrance) Removal - Lexmark X850e Service Manual

Sensor (finisher media entrance) removal

1.
Open the front door assembly.
2.
Remove the rear upper cover. See
3.
Remove the top cover. See
4.
Remove the left lower cover. See
5.
Remove the left upper cover. See
6.
Disconnect the connector from the sensor (finisher media entrance) (A).
7.
Release the harness from the clamp.
8.
Remove the screw securing the bracket (B) to the media entrance pinch guide assembly (C).
Connector
9.
Release the hooks securing the sensor (finisher media entrance) (A) to the bracket (B).
10.
Remove the sensor (finisher media entrance) (A).
"Rear upper cover removal" on page
"Top cover removal" on page
"Left lower cover removal" on page
"Left upper cover removal" on page
A
Clamp
Left
4-101.
4-96.
4-105.
4-106.
B
C
Repair information
7500-XXX
4-175