Sensor (punch unit motor encoder) removal
1.
Open the finisher front door assembly.
2.
Remove the rear upper cover. See
3.
Remove the punch carriage assembly. See
4.
Disconnect the connector from the punch unit motor assembly (A).
5.
Disconnect the connector from the sensor (punch unit motor encoder) (B).
6.
Remove the harness from the clamp.
7.
Remove the two screws securing the bracket (C) to the punch unit assembly (D).
Connector
8.
Release the hooks securing the sensor (punch unit motor encoder) (B) to the bracket (C).
9.
Remove the sensor (punch unit motor encoder) (B).
"Rear upper cover removal" on page
B
C
Clamp
"Punch carriage assembly removal" on page
B
A
7500-XXX
4-101.
4-118.
D
4-125
Repair information