Samsung Ubigate iBG2016 Configuration Manual page 76

CHAPTER 1. Serial Interfaces
Step
10
11
12
Configuring Example
The following figure illustrates a connection of Ubigate iBG2016 configured
as a DCE.
The following example shows the commands used to configure the connection
in The figure.
Router# configure terminal
Router/configure# module serial 1/0
Router/configure/module/serial (1/0)# mode V.35
Router/configure/module/serial (1/0)# v35
Router/configure/module/serial (1/0)/v35# mode dce
Router/configure/module/serial (1/0)/v35# clock_rate 2000000
Router/configure/module/serial (1/0)/v35# clock_source
internal
Router/configure/module/serial (1/0)/v35# crc 16
Router/configure/module/serial (1/0)/v35# data_mode normal
Router/configure/module/serial (1/0)/v35# name serial
Router/configure/module/serial (1/0)/v35# end
Router# show module configuration serial 1/0
42
Command
Router/configure/serial([slot/port])/V
35# name {name string}
Router/configure/serial([slot/port])/V
35# end
Router# show module configuration
serial [slot/port]
(V.35 DTE)
Router
Name the interface.
Returns to the 'Router#' prompt.
Show configured information of
the [slot/plort] serial interface.
(V.35 DCE)
V.35
iBG2016
© SAMSUNG Electronics Co., Ltd.
(Continued)
Purpose