Samsung Ubigate iBG2016 Configuration Manual page 577

This procedure is much like the same as the configuration of E1 trunk.
Step
1
2
3
4
5
6
7
8
9
© SAMSUNG Electronics Co., Ltd.
Command
show voice card all
show module
configuration all
configure terminal
system carrier-type
slot # t1
configure terminal
module t1 trunk#
clock_source
{ internal | line }
framing { esf | d4 }
linecode { b8zs | ami }
Ubigate iBG2016 Configuration Guide/Ed.00
Purpose
List all the voice cards installed in the system.
If you find any of the WTE_XX card you can
choose the one to use a T1 trunks card.
Displays all the digital trunk active in the system.
So if you use this command it helps you to
recognize the carrier-types of the trunks installed in
the system.
Enter the global configuration mode to advance the
T1 setting.
Input the slot# which is qualified to be T1 trunk
card.
And if the previous carrier-type of the slot is
configured T1, rebooting is not required. Otherwise
the system will prompt you to reboot the system for
the change to take effect.
-
Specify the T1 trunk that you want to configure
physical layer settings.
trunk# is a simple notation of slot/sub-slot/port, for
convenience.
Configures the clock source.
line-Specifies that the clock-facility on this port
derives clocking from the external source to which
the port is connected(generally the CO).
internal-(Optional) Specifies that the clock is generated
from the voice card's internal clock-facility.
Selects frame type for T1 or E1 line.
esf-Extended super frame framing format for T1.
d4-Super frame framing format for T1
disable-Disables E1 framer.
Specifies the line encoding to use.
The keywords are as follows:
ami-Specifies the alternate mark inversion(AMI)
line code type.(T1 and E1)
b8zs-Specifies the binary 8 zero substitution line
code type.(T1)
523