Samsung Ubigate iBG2016 Configuration Manual page 144

CHAPTER 5. OSPF
Configuring Bundle Interface: T1 PPP
Configuring Step
Step
1
2
3
4
3
Configuring Example
The following example shows the commands used to configure the bundle
interface.
iBG2016/configure# interface bundle WAN
iBG2016/configure/interface/bundle WAN# link t1 1/1
iBG2016/configure/interface/bundle WAN# encapsulation ppp
iBG2016/configure/interface/bundle WAN# ip address
20.20.20.1 24
iBG2016/configure/interface/bundle WAN# exit
iBG2016/configure#
108
Command
iBG2016/configure# interface
bundle [Bundle Name]
iBG2016/configure/interface/bundle
[Bundle name]# link t1 { [slot/port] |
[slot/subslot/port] }
iBG2016/configure/interface/bundle
[Bundle name]# encapsulation ppp
iBG2016/configure/interface/bundle
[Bundle name]# ip address
[IP address] { [bit mask] | [number
of bits for mask] }
iBG2016/configure/interface/bundle
[Bundle name]# exit
Purpose
Enters the bundle interface
configuration mode.
Links T1 interface to the
[Bundle Name] bundle interface
Selects PPP as an encapsulation
method.
Sets the bundle interface ip
address.
Returns to the upper
configuration level
© SAMSUNG Electronics Co., Ltd.