CHAPTER 3. SIP Gateway Management
Configuring Call Manager
This section describes the configuration necessary for interworking with Call
Manager. All calls of Ubigate iBG2016 in a Call Manager Inter-working mode
pass through Call Manager.
You can specify the SIP signaling IP Address and port of Call Manager using
ip-address command in a call-server configuration mode, and also specify
optionally the registration expire value in a Call Manager Inter-working mode.
The gw-uri command in a call-server configuration mode specify the URI
where a Ubigate iBG2016 will be registered in Call Manager, registration
expire value, and the interval of reattempt upon registration fail. Depending on
the registration status of the URI specified by gw-uri command, it is divided
into Call Manager Inter-working and Survivable Telephony mode.
You can make a setting which enables SIP registration in Call Manager per
dial-peer using register command in a dial-peer configuration mode.
Prerequisites for Call Manager Configurations
For interworking with Call Manager, the registration information of a relevant
Ubigate iBG2016 should be registered in advance. For more information, see
the Call Manager manual.
You should disable SIP service before setting the Call-server. You cannot set
the call server while SIP service is enabled.
How to Configure Call Manager
You can set the call server in the following way.
Configuration Steps
configure terminal
−
voip-gateway
−
call-server
−
ip-address
−
gw-uri
−
exit
−
exit
−
Detailed Steps
364
© SAMSUNG Electronics Co., Ltd.