Samsung Ubigate iBG2016 Configuration Manual page 571

Step
7 caller-digits
8 default
9 dnis-digits
10 invert-abcd
11 ka
12 kd
13 metering
14 nc-congestion
15 request-category
16 unused-abcd
17 exit
18 exit
Country Variant Parameters
1.
ANI digits
Expected number of ANI digits.
sets up the maximum and minimum digits of ANI digits that the receiver
wants to get from the calling side.
2.
Answer signal
Answer signal to be used.
determines a signal to inform that the terminating side has collected all
information for call connection. Distinguishes Group A and Group B, and
sets up signal number of the group determined.
3.
Caller digits
The number of digits to collect before it requests ANI or CallerID
information.
The receiver side sets up the number of DNIS digits to receive ANI digits.
After reception of the digits as many as the number set up, and requests ANI.
© SAMSUNG Electronics Co., Ltd.
Command
Specifies the number of digits needed to be
collected before it requests ANI.
Sets a command to its default setting.
Specifies the expected number of DNIS digits.
Specifies the inversion of the ABCD bits before
tx and after rx.
Specifies the KA signal code ranging from 1 to 15.
Specifies the KD signal code ranging from 1 to 15.
Specifies sending a metering pulse when the
gateway is making an outgoing call.
Specifies the noncompelled congestion signal.
DNIS digits to be collected before requesting a
line category.
Specifies unused ABCD bit values.
Exit the cas-custom configuration mode.
Exit the voice-port configuration mode.
Ubigate iBG2016 Configuration Guide/Ed.00
Purpose
(Continued)
517