Samsung Ubigate iBG2016 Configuration Manual page 540

CHAPTER 5. Analog Voice Port
Step
10
11
12
13
14
15
486
Command
no shutdown
exit
dial-peer voice {pots | voip}
tag
Example)
/configure# dial-peer voice
pots 11
destination-pattern WORD
Example)
/configure# voice-port>
destination-pattern 1004
port slot/subslot/port
exit
Purpose
Change shutdown Status of voice-port to
in-Service
Exits voice port configuration mode
Enters dial-peer configuration mode and
defines a local dial peer that connects to a
POTS interface.
The number argument is one or more digits
identifying the dial peer. Valid entries are
from 1 to 10000.
The pots keyword indicates a dial peer
using basic
telephone service.
Setting Destination-pattern
Matches dialed digits to a telephony device.
The string argument is a series of digits
that specify the E.164 or private dialing
plan telephone number.
Valid entries are the numbers 0 through 9
and the letters A through D.
You can also enter the following special
characters:
- The asterisk (*) or pound sign (#) on
standard touch-tone dial pads can be used
anywhere in the pattern.
- The period (.) acts as a wildcard character.
When the timer(T) character is included at
the end of the destination pattern, the
router collects dialed digits until the
interdigit timer expires(5 seconds, by
default) or until you dial the termination
character(the default is #). The timer
character must be a capital T.
Maps the dial peer to a specific Port Number
Exits voice dial-peer configuration mode
© SAMSUNG Electronics Co., Ltd.
(Continued)