Samsung Ubigate iBG2016 Configuration Manual page 423

Step
3 destination-pattern dest-pattern
Example)
/configure/ dial-peer/voice/voip 100#
dest-pattern 1234
4 session target sip-server
Example)
/configure/ dial-peer/voice/voip 100#
session target sip-server
5 exit
Example)
/configure/dial-peer/voice/voip 100#
exit
Configuring SIP Registrar
This section describes how to set the SIP Registrar used in a Stand-Alone
mode. Together with SIP Registrar setting, you can register POTS dial-peer to
each SIP Registrar using a register command in a POTS dial-peer
configuration mode.
Restrictions for SIP Registrar
You can set SIP Registrar only when Call Manager is not set already.
You cannot set SIP Registrar in a Call Manager Inter-working mode or
Survivable Telephony mode. To set SIP Registrar, first you must cancel the call-
server setting using no call-server ip-address command. This changes the operation
mode to Stand-Alone mode.
© SAMSUNG Electronics Co., Ltd.
Command
Ubigate iBG2016 Configuration Guide/Ed.00
Purpose
Sets a destination pattern.
Sets the session target as sip-
server.
Exits the current mode
(Continued)
369