Samsung Ubigate iBG2016 Configuration Manual page 631

In most cases, it is sufficient in connecting call with the basic value of POTS
dial peer configuration command except the above setup.
To configure POTS dial peer, use the following command starting in global
configuration mode.
Configuration Steps
configure terminal
−
dial-peer voice pots <num>
−
destination-pattern <digit-string>
−
port <string>
−
exit
−
Detailed Steps
Step
1 configure terminal
Example)
# configure terminal
2 dial-peer voice pots num
Example)
sbm/configure# dial-peer
voice pots 10
3 destination-pattern
[+]string[T]
© SAMSUNG Electronics Co., Ltd.
Command
Ubigate iBG2016 Configuration Guide/Ed.00
Purpose
Enters global configuration mode.
Enters dial-peer configuration mode and
defines a local dial peer that connects to a
POTS interface.
The number argument is one or more digits
identifying the dial peer. Valid entries are from
1 to 10000.
Matches dialed digits to a telephony device.
The string argument is a series of digits that
specify the E.164 or private dialing plan
telephone number.
Valid entries are the numbers 0 through 9.
You can also enter the following special
characters:
- The asterisk(*) or pound sign(#) on standard
touch-tone dial pads can be used anywhere
in the pattern.
- The period(.) acts as a wildcard character.
577