Samsung Ubigate iBG2016 Configuration Manual page 587

Timing Settings
To change timing parameters, use the following commands as appropriate, in
voice-port configuration mode.
Step
1
2
3
4
5
6
7
8
9
10
11
© SAMSUNG Electronics Co., Ltd.
Command
voice-port slot/sub-
slot/port:ds0-group-no
timing clear-wait
milliseconds
timing delay-duration
milliseconds
timing delay-start
milliseconds
timing dialout-delay
milliseconds
timing digit
milliseconds
timing guard-out
milliseconds
timing hookflash-out
milliseconds
timing wink-duration
milliseconds
timing wink-wait
milliseconds
Exit
Ubigate iBG2016 Configuration Guide/Ed.00
Purpose
To set up the attribute values of created ds0-
group, enter voice-port configuration mode.
(E & M only) Specifies the minimum amount of
time between the inactive seizure signal and
clearing of the call. Valid entries for the
milliseconds argument are from 200 to 2000
milliseconds. The default is 400.
(E & M only) Specifies the delay signal duration for
delay-dial signaling in milliseconds. Valid entries
are from 100 to 5000. The default is 2000.
(E & M only) Specifies minimum delay time, in
milliseconds, from outgoing seizure to outdial
address. Valid entries are from 20 to 2000.
The default is 300.
Specifies dialout delay, in milliseconds, for the
sending digit or cut-through on an FXO trunk or
an E & M immediate trunk. Valid entries are
from 100 to 5000. The default is 300.
Specifies the DTMF digit signal duration in
milliseconds. Valid entries are from 50 to 100.
The default is 100.
(FXO ports only) Specifies the duration in
milliseconds of the guard-out period that
prevents this port from seizing a remote FXS
port before the remote port detects a
disconnect signal. The range is from 300 to
3000. The default is 2000.
Specifies the duration, in milliseconds, of the
hookflash. Valid entries are from 50 to 500.
The default is 300.
(E & M only) Specifies maximum wink-signal
duration, in milliseconds, for a wink-start signal.
Valid entries are from 100 to 400. The default is
200.
(E & M only) Specifies maximum wink-wait
duration, in milliseconds, for a wink-start signal.
Valid entries are from 100 to 5000. The default is
200.
Exit the voice-port configuration mode.
533