Samsung Ubigate iBG2016 Configuration Manual page 635

Step
5 codec { g711alaw |
g711ulaw | g723r53 |
g723r63 | g726 | g729 }
[ptime]
Example)
sbm/configure/.../voip num#
codec g711alaw
Configuring Codec Selection Order
VoIP dial-peer can basically possess system codeclist. System codec list is the
list including only with g729. Both codec and codec-list can be designated in
dial-peer and codec list gets priority.
Designating the order of codec in Voice class can make list. Designating this
list with either dial-peer or system codec list is possible.
The method to make codec list is as follows.
Setp
1 voice class codec num
Example)
sbm/configure# voice class
codec 1
2 codec-preference prefer-num
{ g711alaw | g711ulaw |
g723r53 | g723r63 | g726 |
g729 } [10/20/30/40/50/60]
Example)
sbm/configure/.../codec num#
codec-preference g711alaw 50
By using 'voice service codec-list' command, set the created voice class codec
with system global codec list. Using system global codec list, assign codec list
in dial-peer.
© SAMSUNG Electronics Co., Ltd.
Command
Command
Ubigate iBG2016 Configuration Guide/Ed.00
Purpose
Defines the codec for the dial peer.
Ptime means the time between frames
transmitted. The unit is msec and has the
value among 10/20/30/40/50/60(g711alaw,
g711ulaw, g726, g729), 30/60(g723r53,
g723r63)
Purpose
Creates a voice class for a codec
preference list. The range for the tag
number is from 1 through 10000.
The number must be unique on the router.
Configures the order of preference for
selecting a codec. Repeat this command to
specify the preferred selection order for
additional codecs, if required.
g723r53, g723r63 : 30/60
g711alaw, g711ulaw, g726, g729 :
10/20/30/40/50/60
(Continued)
581