Samsung Ubigate iBG2016 Configuration Manual page 604

CHAPTER 7. ISDN
Configuring Voice type
To configure the voice type, use the following command.
Step
1 configure terminal
2 iInterface bundle bundle-
name
3 link bri 0/0/0:1
4 isdn
5 switch-type switch-type
6 incoming-voice
7 spid1 spid-number
8 spid2 spid-number
9 sending-alerting
10 overlap-receiving
11 tei-mode [point-to-
point|point-to-multipoint]
12 tei-vale num
550
Command
Configures to set up bundle.
Sets up bundle name.
Sets up the pertinent physical link.
Sets up ISDN
Sets up the pertinent switch-type with the
content like the following table.
Sets up for voice.
(Optional: TE Only) Spefies a service profile
identifier for B1 channel. Currently, only the
DMS-100 and NI switch types require SPIDs.
(Optional: TE only) Specifies a SPID for B2
channel.
(Optional) Specify if Alerting message to be
sent out before Connect message.
(Optional) Specify if the interface will do
Overlap Receiving.
(Optional) Configure the type of tei negotiation
(Optional) Configure the tei value for Point-to-
Point tei mode.
Purpose
© SAMSUNG Electronics Co., Ltd.