Samsung Ubigate iBG2016 Configuration Manual page 527

Step
9 timeouts timer-name
timer-value
10 timing hookflash-out
timer-value
11 no shutdown
12 exit
13 dial-peer voice {pots |
voip} tag
Example)
/configure# dial-peer
voice pots 11
© SAMSUNG Electronics Co., Ltd.
Command
interdigit - Configures the number of seconds that
the system waits after the caller has input the
initial digit or a
subsequent digit of the dialed string. If the timeout
ends before the Destination is identified, a tone
sounds and the call ends. This value is important
when using variable-length dial peer destination
patterns(dial plans).
The seconds argument is the
interdigit timeout wait time in seconds.
A valid entry is an integer from 0 to 120. The
default is 5.
ringing - Specifies the duration that the voice port
allows ringing to continue if a call is not answered.
The range is from 0 to 60000.
The default is 180. 0 means infinity.
wait-release - Specifies the duration that a voice
port stays in the call-failure state while the device
sends a busy tone, reorder tone, or an out-of-
service tone to the port.
The range is from 0 to 3600. The default is 30. 0
means infinity.
the duration of the hookflash, in miliseconds
Change shutdown Status of voice-port to in-
Service
Exits voice port configuration mode
Enters dial-peer configuration mode and defines a
local dial peer that connects to a POTS interface.
The number argument is one or more digits
identifying the dial peer. Valid entries are from 1 to
10000.
The pots keyword indicates a dial peer using basic
telephone service.
Ubigate iBG2016 Configuration Guide/Ed.00
Purpose
(Continued)
473