Samsung Ubigate iBG2016 Configuration Manual page 578

CHAPTER 6. Digital Voice Port
Step
10
11
Create DS0 Groups on a Digital T1 Trunk
This procedure is much like the same as the configuration of E1 trunk.
Step
1
2
3
4
5
v239# show voice port summary
PORT
======== == ========== ===== ==== ============= ============ ==
0/0/0
0/0/1
0/0/2
0/0/3
0/1/0:10 -- ---
524
Command
Exit
show module
configuration t1
trunk#
Command
configure terminal
module t1 trunk#
cas-ds0-group ds0-
group-no
exit
show voice port
summary
CH SIG-TYPE ADMIN OPER IN STATUS
-- fxs-ls up
-- fxs-ls up
-- fxs-ls up
-- fxs-ls up
down
Purpose
exit to the global configuration mode. Keep in mind
that no-shutdown is not necessary as the settings
are applied instantly.
Check out the status of the specified trunks and the
sanity.
trunk# is a simple notation of slot/sub-slot/port, for
convenience.
Purpose
Assumes the trunk becomes normal active according
to the steps above. Here the description starts with
configuring CAS signaling to trunk.
Enter the module configuration mode.
Enter the ds0-group number to create in this T1
trunk.
Exit module configuration mode.
Check if ds0-group is normally created.
Ds0-group created in the system is displayed in the
status of slot/sub-slot/port:ds0-group-no.
up on-hook
up on-hook
up on-hook
up on-hook
-- ----
(Continued)
OUT STATUS EC
idle y
idle y
idle y
idle y
---- y
© SAMSUNG Electronics Co., Ltd.