Samsung Ubigate iBG2016 Configuration Manual page 499

How to configure RRQ TimeToLive
'ras rrq-ttl' command specifies the time which should be considered as that
H.323 gateway is running after a gatekeeper receives the lightweight RRQ for
the last time. H.323 gateway sets this value(TimeToLive value) within a RRQ
message and sends it to a gatekeeper. If the lightweight RRQ is not sent out
from H.323 gateway within the specified time, a gatekeeper determines that
the H.323 gateway has a problem, and changes the status to a unregistration
status.
You can set the TimeToLive value to RRQ message in the following way.
Configuration Steps
configure terminal
−
voice service h323
−
ras rrq-ttl
−
exit
−
Detailed Steps
Step
1 configure terminal
Example)
# configure terminal
2 voice service h323
Example)
/configure# voice service h323
3 ras rrq-ttl time-to-live
Example)
/configure/voice/service/h323#r
as rrq-ttl 60
5 exit
Example)
/configure/voice/service/h323#
exit
© SAMSUNG Electronics Co., Ltd.
Command
Ubigate iBG2016 Configuration Guide/Ed.00
Purpose
Enters global configuration mode.
Enters 'voice service h323' configuration
mode.
Sets time-to-live parameter. Argument is
as follows:
- time-to-live:How long, in seconds, the
gatekeeper considers the gateway active.
Range: 15 to 300
Exits the current mode
445