Samsung Ubigate iBG2016 Configuration Manual page 445

Configuring QSIG tunneling over SIP
This section describes how to make the settings necessary to deliver QSIG
message via SIP signaling. Ubigate iBG2016 provides the function to load
QSIG message in SIP message. Its purpose is for QSIG message to be
delivered transparently in SIP section, when different QSIG network is
connected to SIP. To do so, it is necessary to enable the QSIG Tunneling
function in VoIP Dial-Peer of SIP type.
How to Configure QSIG Tunneling
You can enable the QSIG Tunneling function in VoIP Dial-Peer of SIP type in
the following way.
Configuration Steps
configure terminal
−
dial-peer
−
sip-class qsig tunneling
−
exit
−
Detailed Steps
Step
1
2
3
4
© SAMSUNG Electronics Co., Ltd.
Command
configure terminal
Example)
# configure terminal
dial-peer voice {pots | voip} tag
Example)
/configure# dial-peer voice voip 100
[no] sip-class qsig tunneling
Example)
/configure/ dial-peer/voice/voip 100#
sip-class qsig tunneling
Exit
Example)
/configure/dial-peer/voice/voip 100#
exit
Ubigate iBG2016 Configuration Guide/Ed.00
Purpose
Enters global configuration
mode.
Enters VoIP dial-peer
configuration mode.
Enables or Disables QSIG
Tunneling feature.
Exits the current mode
391