Samsung Ubigate iBG2016 Configuration Manual page 726

CHAPTER 11. Management
Voice Protocol Module debug mode
This is the function that shows debug messages of the layer close by a device
on ports side.
There are parameters of in/out/all that set up Incoming/Outgoing, and
deb0/deb1/info/all that set up levels.
Debug vpm asi
Debug vpm ati
Debug vpm dti
Debug vpm ssi
H323 debug mode
This is the function that shows a debug message of H323, and shows the
contents of stack and call-control.
Log displays an appropriate calling number and called number, All displays a
debug message regardless of calling/called number.
Debug h323 stack
Debug h323 vcc
Debug h323 log
SIP debug mode
This is the function that shows a debug message of SIP, and shows the
contents of stack and call-control.
Dump is the function that shows a SIP message.
Log displays an appropriate calling number and called number, All displays a
debug message regardless of calling/called number.
672
Table 11.12 Voice Protocol Module Debug
Command
Table 11.13 H323 Debug
Command
Purpose
Analog Sub Interface debug
Analog Trunk Interface debug
Digital Trunk Interface debug
Signal Interface
Purpose
h323 stack related command
h323 Voice Call Control related command
h323 calling or called number log related
command
© SAMSUNG Electronics Co., Ltd.