Samsung Ubigate iBG2016 Configuration Manual page 457

Configuring SIPS URI with TLS transport
This section describes how to set SIP signaling via TLS connection. To do this,
set URI type to SIPS, and change the transport type to TLS. You can change
the URI type and transport type in two ways. That is, you can make a setting
which applies to the entire SIP signaling, or individual dial-peers of SIP type.
How to Configure SIP URI with TLS transport for All SIP Calls
You can perform system global configuration for SIP URI with TLS transport
in the following way.
Configuration Steps
configure terminal
−
voice service sip
−
uri
−
transport
−
exit
−
Detailed Steps
Step
1 configure terminal
Example)
# configure terminal
2 voice service sip
Example)
/configure# voice service sip
3 uri [sip | sips]
Example)
/configure/ voice/service/sip# uri sips
4 transport [udp | tcp | tls]
Example)
/configure/ voice/service/sip# transport tls
5 Exit
Example)
/configure/voice/service/sip# exit
© SAMSUNG Electronics Co., Ltd.
Ubigate iBG2016 Configuration Guide/Ed.00
Command Purpose
Enters global configuration
mode.
Enters SIP Service
configuration mode.
Specifies SIP URI type. sip or
sips is available.
Specifies SIP transport type.
udp, tcp or tls is available.
Exits the current mode
403